MADE IN USA Cuervo Yamaha Raptor 700 Reducer OIL DRAIN PLUG kit BEFORE u strip

Description

The Original Drain plug reducer From CUERVO, Not a cheap China copy, dont be fooled even though they copied our complete listing.
Made here in The USA of high strength 7071 aluminum
The kit is for your Raptor 700 Crankcase. It reduces the size of the Drain bolt from 14x1.5 to 8x1.25 and is a permanent installation.
This eliminates the fear or stripping out the threads on the crankcase.
A new drain bolt and washer are included and are the same size as the oil tank hardware.
Fits 2006 2007 3008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 raptor 700 base. R AND se
Product Is Clear Anodized finish
Please use the Following Installation information.
*Safely Tilt bike back on end and remove factory drain plug.
*clean case threads and mating surface, must be clean and dry.
*use Red or Blue  loctite on outer threads of Reducer, (the loctite when cured will seal the threads)
*can be installed With or Without oem crush washer.
*tighten reducer to oem spec and then tighten drain bolt(drain bolt now uses and gets the same spec tq as oil tank bolt).
*let sit in upright position until the proper cure time on the Loctite used.
If your crankcase has Already been repaired and is leaking you may use this as well,  sometimes thread sealant or silicone is required if the job was done poorly.
Check out our Youtube channel MrCuervoRacing